7 Do-It-Yourself Water Damage Tips

If you find your home suffering from water damage, you need to act fast. The effects that water can have on the structural integrity of your home – never mind the aesthetics of your ceiling or walls – can be more than a little worrisome. Take care of water damage (see the Mold Remediation Pros if you’re in Atlanta) with these seven easy do-it-yourself tips, and keep your family and your home healthy and safe!


DIY Tip #1: Determine the Issue
Perhaps there have been torrential rain storms and downpours that have left a damp feeling in your home. Or a pipe has burst and the water is flooding into your bathroom. Whatever the reason for the onslaught of water, determining that you have a water damage issue begins the steps necessary for repair.

DIY TIP #2: Find the Source of the Leak
If you already have water flooding into your kitchen, or slowly dripping from a light fixture underneath a bathroom into the bedroom below, you will have discovered the source of the leak. If, however, you are suddenly noticing bubbling paint or discolored wall or ceiling areas, that is also a signal of water leaking. Go into the attic or crawl onto the roof on a dry day, to find the point of wetness or water seepage that is causing your water damage.


DIY Tip #3: Stop the Leak Source
Once you have determined the source of your leak, stop the water from continuing to enter your home. Replace the faulty roof shingles or replace the pipe that might be leaking or busted. Once the water stops entering your home, you can set about repairing the damage that has been done.

DIY Tip #4: Dry Out the Leak Source
Now you must dry the affected area of your home, both above and below the damaged point. Make it a point to dry your wall, ceiling or floor thoroughly, with fans and towels, and do as much as you can to dry out the other side of the visible damage as well. Ensuring the damaged area is fully dry will also protect against mold growth.

DIY Tip #5: Remove the Damage
To effectively repair water damage, the portion of the wall or ceiling that is damaged needs to be removed. If your ceiling has bubbled, use a puddy knife to cut away the ruined paint. If there is no visible damage to your walls or ceiling, they may stay as-is once they are completely dry. You can learn more by looking at reviews such as this one: http://www.yelp.com/biz/mold-remediation-pros-atlanta.

DIY Tip #6: Prepare to Repair
Before you repaint, refinish, or re-stucco the now-removed areas of the wall or ceiling, make sure you sand down the exposed wall or ceiling to ensure a smooth finish relative to the rest of the still-painted area. Remove any bumps with sandpaper to ensure a smooth surface.

DIY Tip #7: Finish Your Repair
Finally, prime your newly repaired wall or ceiling area to ensure protection against future damage. Once the primer coat has dried and set, repaint to match your current paint job. If the only damage left visible to your home is discoloration – and the wall or ceiling is completely dry to the touch – you should still prime the area before you paint.